UK road marking standards explained, from CS 126 to the PRIME trials

A guide to UK road marking standards: what the law and national specifications require, how wear and night-time visibility are measured, who must renew faded lines and what recent trials found.

A white line is a traffic sign in law, and like any sign it stops working when drivers cannot see it. The Road Traffic Regulation Act 1984 counts “any line or mark on a road” that conveys a warning or requirement as a traffic sign. Regulations, British Standards and national specifications then set how bright, grippy and durable those lines must be. This guide puts those road marking standards, and the trials, in one place.
In brief:
- New white lines on UK motorways and trunk roads must meet set classes for night-time brightness, wet visibility and skid resistance from BS EN 1436 for at least two years after they are laid.
- In service, the road marking standards in CS 126 set the points at which worn, dim or slippery markings become defects, but we found no published national figure for how many lines fall below them.
- Transport Scotland’s PRIME motorcycle markings cut speeds at 13 of 18 trial sites in 2023 to 2025, and it reports a 61% fall in motorcycle injury collisions across its trial sites. Wales began its own trial in August 2025, and the Department for Transport’s January 2026 road safety strategy backs pilots in new regions.
Last updated: 21 October 2026
What do road marking standards in the UK require?
The Traffic Signs Regulations and General Directions 2016 (TSRGD), which apply in England, Wales and Scotland, say a road marking “may be reflectorised”, subject to rules for particular markings. The Department for Transport’s Traffic Signs Manual Chapter 5 says most markings with a guidance function must be, and lists them, edge lines and double white lines among them. Under regulation 10, no marking may stand more than 6 mm above the carriageway unless the regulations provide otherwise. Northern Ireland has its own 1997 regulations; the manual lists the variations.
Performance against road marking standards is graded under BS EN 1436:2018, which sorts markings into classes for daytime luminance (Q or B), dry night-time retroreflectivity (R), retroreflectivity when wet (RW) and in rain (RR), and skid resistance (S). Durability is proved in road trials to BS EN 1824:2020. Retroreflectivity is measured in mcd/m²/lx: the higher the number, the brighter the line in headlights.
More glass beads make a line brighter at night but reduce skid resistance, so the manual says the top class cannot practicably be specified for both. Our road marking coverage returns to that trade-off often.
On motorways and trunk roads the road marking standards for new work are set by CC 120, published on 30 September 2025 in the Manual of Contract Documents for Highway Works. White lines must meet them for at least two years after installation or opening to traffic, whichever is later. In-service thresholds come from CS 126 in the Design Manual for Roads and Bridges.
| Requirement | Value or class | Where it is set |
|---|---|---|
| Reflectorisation | Any marking may be reflectorised; markings listed in TSRGD must be (Table 12-1 of the manual lists them) | TSRGD 2016 reg 9; Traffic Signs Manual Ch 5 |
| Maximum height | 6 mm above the carriageway unless provided otherwise; raised rib upstand no more than 11 mm (motorway diagram 1012.2) or 8 mm (diagram 1012.3) | TSRGD 2016 reg 10; Traffic Signs Manual Ch 5, 2.6 |
| New white lines: dry night-time brightness | R2 (100 mcd/m²/lx) on lit roads of up to three lanes; R3 (150) on unlit roads of up to three lanes and lit roads of four or more; R4 (200) on unlit roads of four or more lanes | CC 120, Table 7.4 |
| New white lines: wet night-time brightness | RW2 (35) on lit roads of up to three lanes; RW3 (50) elsewhere. No value set for rain (RR0) | CC 120, Table 7.4 |
| New lines: daytime brightness | White: Q3 (130) or B2 (0.30) up to three lanes, Q4 (160) or B3 (0.40) for four or more. Yellow: Q2 (100) or B1 (0.20) | CC 120, Tables 7.4 and 7.5 |
| New lines: skid resistance | S1 (45 on the skid resistance tester); the manual advises 55 for yellow bar markings | CC 120; Traffic Signs Manual Ch 5, 12.6.2 |
| New lines: durability | P5: one million wheel passages in a BS EN 1824 road trial | CC 120, Tables 7.4 and 7.5 |
| In service: dry brightness defect | Below 100 (lit) or 150 (unlit) for line type (a); below 80 (lit) or 120 (unlit) for line type (b) | CS 126, Table B.2 |
| In service: wet brightness defect | Below 35 where the marking was specified for wet performance | CS 126, Table B.2 |
| In service: wear defect | Average visual score below 30 on a 0 to 50 scale | CS 126, Tables B.1 and B.2 |
| In service: skid defect | Below 55 in critical areas such as Give Way and Stop lines; below 45 elsewhere | CS 126, Table B.3 |
| Age with no records | Treated as a critical defect three years after laying, or two years in critical areas, if no functional life or performance is recorded | CS 126, Section 4 |
“Unlit” in CC 120 includes partially lit and dimmed roads. Check CS 126, Appendix B, for which lines count as type (a) or (b).
How is road marking condition measured?
CS 126, last updated in May 2022, sets how markings and road studs on motorways and all-purpose trunk roads are inspected. It replaced TD 26/17. It asks for risk-based inspection where data allows, and a fixed frequency where it does not, covering wear, dry and wet retroreflectivity, colour, luminance and skid resistance.
Wear is scored by eye on a scale from 0 (residue only) to 50 (no obvious wear) and averaged over 100 m. Vehicle-mounted retroreflectometers survey at traffic speed. Handheld devices are used during closures, on markings such as Stop lines and arrows, and for all wet readings. Skid resistance is taken with the British pendulum.
Without machine data, surveyors check how far ahead a line can be seen at night against an absolute minimum preview time of 1.8 seconds and a desirable minimum of 2.2 seconds: at 70 mph that means 56 m and 69 m. Readings from a surveyor under 30 are cut by about 14% to allow for age; the Traffic Signs Manual notes a 70-year-old may see a marking at a distance more than 20% shorter than drivers in their twenties.
Proposals to dim or switch off street lights must be backed by a condition assessment of markings and studs less than six months old, and dimmed roads are inspected as if unlit.
Who is responsible for maintaining road markings?
In England and Wales the highway authority must maintain highways maintainable at public expense under section 41 of the Highways Act 1980, and traffic authorities place signs, including markings, under section 65 of the Road Traffic Regulation Act 1984. Motorways and trunk roads fall to National Highways in England and the national road authorities in Scotland, Wales and Northern Ireland, which apply CS 126. Local roads fall to councils.
The Traffic Signs Manual says regulatory markings must be maintained if they are to be enforced. It sets no renewal intervals, since these depend on line type, material and traffic, but asks authorities to keep markings under review, renew them soon after resurfacing and sign “NO ROAD MARKINGS” where temporary lines cannot be laid. Our directory of road marking contractors lists firms that do the work, and our report on road marking work on the A30 shows what trunk road relining involves.
How bad is the road marking backlog?
We found no national dataset on road marking condition from the Department for Transport or National Highways. Most public evidence comes from industry.
The Road Safety Markings Association (RSMA), an industry body representing road marking companies, published a survey of 2,000 UK drivers in April 2026. It found that 23% avoid certain roads at night at least once a week because of visibility worries, rising to 41% of drivers aged 18 to 24, and that 73% feel safer on roads with edge lines. These are perceptions, not measured condition, and RSMA members benefit from more lining work. In July 2024 the association asked the then Transport Secretary, Louise Haigh, for ring-fenced marking maintenance funding.
The RAC found something similar in January 2026: 92% of drivers it surveyed said faded road markings had made driving more hazardous. That is also a measure of perception, not condition, but it comes from outside the marking industry.
Which road marking trials should you know about?
| Trial | Who and where | What was tested | What happened | Source |
|---|---|---|---|---|
| 1. PRIME motorcycle markings | Transport Scotland; 22 trial sites and two comparison sites in the West Highlands, 2020 to 2022 | “Gateway” markings on the approach to demanding bends, laid in high-performance tape | 32,213 motorcycles observed. Significant speed reductions at 10 sites, better position at the final gateway at 15, less braking at nine. Speed and position effects still present at a two-year review; no change at comparison sites | Transport Scotland summary report, 13 July 2023 |
| 2. PRIME phase 2 | Transport Scotland; 18 trial sites (13 new, five reused) and two comparison sites in the West Highlands, 2023 to 2025 | The same “gateway” markings on more demanding bends, including whether the effects last and carry over | 15,557 motorcycles observed. Significant speed reductions at 13 sites, better position at the final gateway at 14, less braking at four (more at one), more use of the markings at 17; no change at comparison sites. Transport Scotland reports a 61% fall in annual average motorcycle injury collisions across trial sites, and 46% in collisions where someone was killed or seriously injured | Transport Scotland summary report, 11 May 2026; Transport Scotland, 19 March 2026 |
| 3. PRIME in Wales | Welsh Government with the North and Mid Wales Trunk Road Agent; A487 Pantperthog, A5 Coed Bwlch near Llangollen, A483 north of Llanbadarn Fynydd and A483 Glascoed Hall south of Newtown, from August 2025 | PRIME markings and signage on the approach to bends | No results published yet | Welsh Government, 11 August 2025 |
| 4. Transforming Road Markings (ghost markings) | National Highways (formerly Highways England) with Roadcare and Kier; M5 northbound, junctions 18 to 20, 2019 to 2021 | £685k competition: 36 entries; eight winners after two million wheel overs at a Madrid test centre; seven products and five line removal systems on the M5 by December 2020 | National Highways (then Highways England) said in December 2020 that results were “very promising”. We could not find the full results published online | GOV.UK, 16 July 2019; GOV.UK, 16 December 2020 |
| 5. Audible markings and a certification site | National Highways with WSP; research, September 2025 to March 2026 | Whether National Highways could run its own road marking certification site on its network to BS EN 1824, and new marking profiles that give an audible or vibrating warning while staying within the legal height limit | The research was due to finish in March 2026. We found no published findings yet | Contracts Finder award notice, 26 September 2025 |
£ figures in this table are rounded (m = million, bn = billion, k = thousand).
PRIME has the strongest published evidence. The Phase 1 report, prepared for Transport Scotland by Open Road Simulation Ltd, found positive changes in speed, position and braking, with no effect at the comparison sites. The phase 2 report, published by Transport Scotland in May 2026, found effects at most of the new sites and evidence that riders’ changed behaviour lasted over two, three and five years. Across both phases, about 48,000 motorcycles were observed.
What does it cost to renew road markings?
We found no national unit cost published by the Department for Transport or National Highways. The Traffic Signs Manual compares materials, not prices: thermoplastic is durable and suits most roads, while paint has a low initial cost and suits markings with little traffic wear, such as edge and yellow lines.
What is changing in road marking standards?
The Department for Transport’s road safety strategy, published in January 2026, commits to support PRIME pilot trials in new regions, subject to technical approval and with monitoring and evaluation. The Welsh Government installed PRIME markings at four sites in North and Mid Wales in August 2025, Transport Scotland says six Scottish councils are considering them for their own roads, and National Highways has asked the Department for Transport for approval to trial them in England. PRIME signs and markings are not currently prescribed in the traffic signs regulations, so any authority using them must first obtain the appropriate authorisation.
BSI lists BS EN 1824 as under review. We will update this guide to road marking standards each year and when a trial reports.
Source: CS 126 Inspection and assessment of road markings and road studs, Standards for Highways, published 30 May 2022
In this story Transport Scotland, National Highways, North and Mid Wales Trunk Road Agent, Road Safety Markings Association



















